Sim2 C3X1080 Manuel d'utilisateur télécharger pdf (Page 7)

C3X1080

ENGLISH

if the image is correctly focused, you should be able to

see each single pixel of the projected image when close

to the screen (Fig. 7).

If this adjustment is insufficient, tilt the projector and cor-

rect the keystone error with the Keystone adjustment in the

Installation menu (Fig. 8a). (More information at page 20)

KEYST ONE

20%

The Orientation adjustment in the Set up menu allows you

to reverse the image vertically and horizontally (Fig. 9), to

allow the projector to be used for desktop front, ceiling

front, desktop rear and ceiling rear installations (Fig. 9).

(More information at page 20)

A 12 Volt output is provided at the rear of the projector (Fig.

10) to operate a motorised screen. The output is activated

(Voltage: 12 Vdc) when the projector is switched on and

is de-activated (no Voltage output) when the projector

is in stand-by mode. You can also use black motorised

curtains to delimit the screen when the projected image

aspect ratio changes (Fig. 11a). This option is controlled

via the output at the rear of the projector.

For rear projection the screen must be translucent.

For front projection, we recommend the use of a screen

with black matt borders to contain the projected image.

Position the projector on a stable, suitable surface or use

the optional ceiling mount bracket.

WARNING: When using the ceiling mount bracket, the

safety instructions provided with the bracket must be

strictly observed. If using a bracket other than them

one supplied by SIM2 Multimedia, make sure that the

projector is installed at least 65 mm below the ceiling

and that the bracket does not obstruct the air vents

(intake and outlet).

If the projected image is not level, adjust the feet on its

base to obtain a level position, lining up the base of the

projected image with the base of the projection screen

(Fig. 6).

Place the projector at the desired distance from the

screen: the size of the projected image depends upon

the distance between the lens and the screen and the

lens zoom setting. Use the motor zoom (Fig. 7) to zoom the

projected image in and out. Use the motor focus function

(Fig. 7) to obtain a clear image;

5 INSTALLATION

Fig. 6

Fig. 7

Fig. 8

ZOOM

FOCUS AUTO ASPECT VCR

HELPZOOM

ZOOM

FOCUS

Fig. 9

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

Commentaires sur ces manuels

Pas de commentaire

Sim2 C3X1080 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Sim2 C3X1080